Group-policy GroupPolicy_Anyconnect attributes Group-policy GroupPolicy_Anyconnect internal With that said, let’s move on to the configurations! Anyconnect Configuration 1: Tunnel All !Enable WebVPN, Set Anyconnect Image, and Enable AnyconnectĪnyconnect image disk0:/anyconnect-win-8-k9.pkg 1Īnyconnect image disk0:/anyconnect-macosx-i386-8-k9.pkg 2Īnyconnect image disk0:/anyconnect-linux-8-k9.pkg 3 They are using outdated “svc” commands, which were replaced with “anyconnect”.
#Bypass k9 web protection v1.2 spiceworks how to
They do not include how to create a split tunnel or a tunnel all to allow internet from the Anyconnect client. The directions do not specify that you MUST attach the VPN Address pool to the tunnel group, which is necessary for it to work!. They are using the default names for configuring the group policy and tunnel groups, which will throw a warning that they already exist since they’re defaults. There are a few important things to note from Cisco’s directions: Add an address pool to assign an ip address to the An圜onnect client Proceed to configure An圜onnect VPN client:Ĩ. If using LOCAL database, add users to the Database Tunnel-group DefaultWEBVPNGroup general-attributesĥ. Tunnel-group DefaultWEBVPNGroup type remote-access Configure AAA authentication and tunnel group Steps to configure a remote access SSL VPN remote access connection and An圜onnect with examples: Here are the results of that command: ciscoasa(config)# vpnsetup ssl-remote-access steps The ASA has a command that gives an overview of how to configure an Anyconnect SSL VPN, which in global configuration mode is vpnsetup ssl-remote-access steps. I will give examples of each configuration below. The below configuration examples assume you have a basic setup equivalent to running factory-default and are setup to authenticate locally to the ASA. In laymen terms, the clients internet traffic originates from their ISP in a split tunnel, and it originates from the ASA when using tunnel all. 
When setting up a Anyconnect VPN tunnel, you can push all traffic from the client over the VPN (Tunnel all) or you can use a split tunnel to only push traffic destined for selected subnets over the VPN tunnel. The below configurations will work with 8.3+, but was written and tested with 9.0. Authentication: Local (Local ASA User Database)
0 kommentar(er)
